Cut a plastic strip with a width of seven or eight millimeters

After roasting it softly, wrap it around the fishing rod and clamp it with pliers. After wrapping, bake the excess parts together with fire, and this step is complete. First remove the old ring on the fishing rod, and use the glass ring on the old ring to cut a plastic strip that is 2.One of the techniques and materials for making sea pole ring: is a yellow plastic tube protected by the heat insulation layer of the heating pipe.

The excess parts stick together. Wait until they cool down and trim them to make one. When they are about to melt, put them together immediately. It has good strength. Use a three-in-one epoxy resin glue to glue the head of the Wholesale fishing swivel snap Supply child firmly, and the whole work is complete. Heating will only melt and burn, but will not be carbonized. 3. Put the two finished parts on the flame and heat them at the same time. This plastic tube is 1. After the shaozi ring is removed, keep the outer plastic jacket. Cut a plastic strip with a width of seven or eight millimeters. The length is 15 millimeters longer than the outer diameter of the fishing rod.

Tie the remaining 15 mm on both sides to the fishing rod with nylon thread. Fifteen mm, put it on the candle flame and slowly bake it until it becomes soft, immediately surround the glass ring to clamp the excess part with pliers, wait for the plastic to cool, and then use the candle flame to slowly bake the plastic around the glass ring. Use your fingers to press the plastic in the middle and wrap the glass ring inside.5 mm thick and can be welded together by hot melt. 2.5 mm stainless steel wire to make a ring and snap it into the outer groove. Use 0. For fishing clubs, use a torch after cooling.5 mm wider than the height of the glass ring, and the length is 10 mm longer than the outer circumference of the glass ring.